1 X 90° Stainless Steel Rod Holder

 

This is a high quality, mirror finished 316 Stainless steel rod holder. 90 degree flush mounted using 3 counter sunk screws.

It comes complete with:

1. Rubber gasket to sit between the rod holder and the boat. This gasket has 2 purposes.
   • Prevents any water on the deck running into the boat via the rod holder cut-out
   • Acts as a barrier between the stainless steel and the aluminium on any alloy boat. This is very important. If these 2 metals touch each other in a salt water enviroment it creates a reaction that increased corrosion. It's a must to have the rubber between the rod holder and boat.
2. Rubber cap to prevent water entering the boat when the rod holder is not in use.
3. Rubber liner / Insert to protect your vaulable rod from wearing away against a hard metal surface.
4. Stopper pin built into the rod holder to stop your rod falling through the rod holder.

If your going to buy a rod hold make sure it has all these features

Measurements

A: Length 220cmm

B: Diametre 50mm

C: Width 120mm